2012Nov GoGopher upgrade by Willis Chung
Back
2012Nov GoGopher upgrade
Justified View
Flow View
Square View
Grid View
Journal View
Highlight View
Large Photo View
Slideshow
Proofing View
TV View
RSS
Willis Chung's Gallery Willis Chung's Gallery
Back

2012Nov GoGopher upgrade
  • Nov 11, 2012
  • 16 Photos
Justified View
Flow View
Square View
Grid View
Journal View
Highlight View
Large Photo View
Slideshow
Proofing View
TV View
RSS
×
  1. Willis Chung's Gallery
  2. 2012Nov GoGopher upgrade2012Nov GoGopher upgrade
A fully digital 8 Gig GoGopher plugged into a USB port!
Here is how to convert an analog GoGopher to a 8 Gig digital GoGopher!
Get: small USB drive with parallel sides, pen, utility knife, tweezers, double sided foam tape.
Place the cap of the thumb drive over the tail, where the drive will be installed
Trace around the cap. Note that the cap is slightly smaller than the thumb drive, good! No wiggles!
With a very sharp utility knife score the lines, then cut deeply.
Clean up the hole and test fit the thumb drive. It's better if the hole is slightly too small.
Build up a platform of strips of double sided foam tape inside.
A pair of tweezers helps place the strips.
Use the back end of the tweezers to press the foam strips down.
As the strips get toward the bottom of the edge of the hole, put lumps of extra tape on the end.
Place the drive into the hole, correct side up! Angle it up, away from the double sided tape.
When the drive is at the correct depth, angle it down, onto the tape.
A fully digital GoGopher, far superior to the conventional analog version!
Thousands of uses! Good for home, office, or recreation!
The cuteness factor is off the scale! GoGopher!
A fully digital 8 Gig GoGopher plugged into a USB port! Here is how to convert an analog GoGopher to a 8 Gig digital GoGopher! Get: small USB drive with parallel sides, pen, utility knife, tweezers, double sided foam tape. Place the cap of the thumb drive over the tail, where the drive will be installed Trace around the cap. Note that the cap is slightly smaller than the thumb drive, good! No wiggles! With a very sharp utility knife score the lines, then cut deeply. Clean up the hole and test fit the thumb drive. It's better if the hole is slightly too small. Build up a platform of strips of double sided foam tape inside. A pair of tweezers helps place the strips. Use the back end of the tweezers to press the foam strips down. As the strips get toward the bottom of the edge of the hole, put lumps of extra tape on the end. Place the drive into the hole, correct side up! Angle it up, away from the double sided tape. When the drive is at the correct depth, angle it down, onto the tape. A fully digital GoGopher, far superior to the conventional analog version! Thousands of uses! Good for home, office, or recreation! The cuteness factor is off the scale! GoGopher!
Scroll To Top

Audio Mute
Prev
Play
Next
Shuffle
Include